D-Link DGS-3620-52T CLI Guide - Page 220

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide Parameters - Enter the maintenance association name used here. This name can be up to 22 characters long. ma_index - Specifies the maintenance association index used. - Enter the maintenance association index value used here. This value must be between 1 and 4294967295. md - Specify the maintenance domain name. - Specify the maintenance domain name. The maximum length is 22 characters. md_index - Specifies the maintenance domain index used. - Enter the maintenance domain index value used here. This value must be between 1 and 4294967295. Restrictions Only Administrator, Operator and Power-User level users can issue this command. (EI Mode Only Command) Example To create a maintenance association called "op1" and assign it to the maintenance domain "op_domain": DGS-3620-28SC:admin#create cfm ma op1 md op_domain Command: create cfm ma op1 md op_domain Success. DGS-3620-28SC:admin# 15-4 config cfm ma Description This command is used to configure the parameters of a maintenance association. The MEP list specified for an MA can be located in different devices. MEPs must be created on the ports of these devices explicitly. An MEP will transmit a CCM packet periodically across the MA. The receiving MEP will verify these received CCM packets from the other MEPs against this MEP list for the configuration integrity check. Format config cfm ma [ | ma_index ] md [ | md_index ] {vlanid | mip [none | auto | explicit | defer] | sender_id [none | chassis | manage | chassis_manage | defer] | ccm_interval [3.3ms | 10ms | 100ms | 1sec | 10sec | 1min | 10min] | mepid_list [add | delete] | mode [software | hardware]}(1) Parameters - Specify the maintenance association name. The maximum length is 22 characters. ma_index - Specifies the maintenance association index used. - Enter the maintenance association index value used here. This value must be between 1 and 4294967295. 215