D-Link DGS-3620-52T CLI Guide - Page 630
config loopdetect ports, enable loopdetect
View all D-Link DGS-3620-52T manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 630 highlights
xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide DGS-3620-28SC:admin#config loopdetect recover_timer 0 interval 20 mode vlanbased Command: config loopdetect recover_timer 0 interval 20 mode vlan-based Success. DGS-3620-28SC:admin# 54-2 config loopdetect ports Description This command is used to set up the loop-back detection function for the ports on the switch. Format config loopdetect ports [ | all] state [enable | disable] Parameters - Specify a range of ports to be configured. all - To set all ports in the system, use the all parameter. state - Specify the status. enable - Enable loop-detect for the ports specified in the port list. disable - Disable loop-detect for the ports specified in the port list. The default is disabled. Restrictions Only Administrator, Operator and Power-User level users can issue this command. Example To set up loop-back detection: DGS-3620-28SC:admin#config loopdetect ports 1-5 state enable Command: config loopdetect ports 1-5 state enable Success. DGS-3620-28SC:admin# 54-3 enable loopdetect Description This command is used to allow the loop detection function to be globally enabled on the switch. The default value is disabled. Format enable loopdetect 625