D-Link DGS-3620-52T CLI Guide - Page 263
config authentication ports
View all D-Link DGS-3620-52T manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 263 highlights
xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide hyphen - Specifies using the "-" as delimiter, the format is: AA-BB-CC-DD-EE-FF colon - Specifies using the ":" as delimiter, the format is: AA:BB:CC:DD:EE:FF dot - Specifies using the "." as delimiter, the format is: AA.BB.CC.DD.EE.FF none - Specifies not using any delimiter, the format is: AABBCCDDEEFF number - (Optional) Specifies the delimiter number used. 1 - Single delimiter, the format is: AABBCC.DDEEFF 2 - Double delimiter, the format is: AABB.CCDD.EEFF 5 - Multiple delimiter, the format is: AA.BB.CC.DD.EE.FF Restrictions Only Administrator, Operator and Power-User level users can issue this command. Example To configure the MAC address format to IETF style: DGS-3620-28SC:admin#config authentication mac_format case uppercase delimiter hyphen number 5 Command: config authentication mac_format case uppercase delimiter hyphen number 5 Success. DGS-3620-28SC:admin# 19-5 config authentication ports Description This command is used to configure authorization mode and authentication method on ports. Format config authentication ports [ | all] {auth_mode [port_based | host_based {vlanid state [enable | disable]}] | multi_authen_methods [none | any | dot1x_impb | impb_jwac | impb_wac | mac_impb]}(1) Parameters - Specify a port or range of ports to configure. all - Specify to configure all ports. auth_mode - (Optional) The authorization mode is port-based or host-based. port-based - If one of the attached hosts pass the authentication, all hosts on the same port will be granted access to the network. If the user fails the authorization, this port will keep trying the next authentication. host-based - Specify to allow every user to be authenticated individually. vlanid - (Optional) Specifies the VLAN ID used for this configuration. - Enter the VLAN ID used for this configuration here. state - (Optional) Specifies whether the authorization mode will be enabled or disabled. enable - Specifies that the authorization mode will be enabled. disable - Specifies that the authorization mode will be disabled. multi_authen_methods - (Optional) Specify the method for compound authentication. none - Specify that compound authentication is not enabled. any - Specify if any of the authentication methods (802.1X, MAC, and JWAC/WAC) pass, then 258