D-Link DGS-3620-52T CLI Guide - Page 173

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide clear_password - Specifies to clear the MD5 authentication password when a TCP connection between BGP neighbors are established. Restrictions Only Administrator, Operator and Power-User level users can issue this command. (EI Mode Only Command) Example To configure a neighbor's description: DGS-3620-28SC:admin# config bgp neighbor 10.10.10.2 description EBGP-neighbor Command: config bgp neighbor 10.10.10.2 description EBGP-neighbor Success. DGS-3620-28SC:admin# 12-23 config bgp neighbor session Description The command is used to configure the state or neighbor's session activity for a BGP neighbor. If a neighbor is specified to be in the disabled state, it is equivalent to the case that the neighbor is deleted except when the neighbor configuration is kept. Format config bgp neighbor session [ | peer_group ] [activity | state] [enable | disable] Parameters - Specifies the IP address of the neighbor to be configured. peer_group - Specifies the peer group to be configured. - Enter the peer group name here. This name can be up to 16 characters long. state - If state is changed from enabled to disabled, the session with the neighbor peer will be terminated. activity - Specify the state for individual address family. By default, the setting is enabled for IPv4 address family. enable - Specifies that the neighbor session state or the for individual address family state will be enabled. disable - Specifies that the neighbor session state or the for individual address family state will be disabled. Restrictions Only Administrator, Operator and Power-User level users can issue this command. (EI Mode Only Command) 168