D-Link DGS-3620-52T CLI Guide - Page 871
config ptp ports, config ptp boundary ports
View all D-Link DGS-3620-52T manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 871 highlights
xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide 79-7 config ptp ports Description This command is used to configure the per port state of the PTP clock. PTP port active state should meet the following three conditions: The global PTP state is enabled. The port PTP state is enabled. The port is not blocked, if the stp state is enabled. Format config ptp ports [ | all] state [enable | disable] Parameters ports - Specifies the list of port used for this configuration. - Enter the list of port used for this configuration here. all - Specifies that all the ports will be used for this configuration. state - Specifies the port state of the PTP clock function. enable - Specifies that the port state of the PTP clock function will be enabled. disable - Specifies that the port state of the PTP clock function will be disabled. Restrictions Only Administrator, Operator and Power-User level users can issue this command. Example To enable PTP on ports 1:1-1:4: DGS-3620-28SC:admin# config ptp ports 1:1-1:4 state enable Command: config ptp ports 1:1-1:4 state enable Success. DGS-3620-28SC:admin# 79-8 config ptp boundary ports Description This command is used to configure the attributes of the PTP boundary clock. The configuration takes effect when the PTP device is a boundary type. Format config ptp boundary ports [ | all] {announce [interval | timeout ] | sync_interval [half_second | ] | delay_req_interval | pdelay_req_interval | delay_mechanism [e2e | p2p]}(1) 866