D-Link DGS-3620-52T CLI Guide - Page 426
External Alarm, Commands
View all D-Link DGS-3620-52T manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 426 highlights
xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide Chapter 32 External Alarm Commands config external_alarm {unit < unit_id>} channel message show external_alarm {unit } 32-1 config external_alarm Description This command is used to configure external alarm message for a channel. The source of alarm is located outside of the switch. They are monitored via pre-defined connection channels, with each channel representing a specific alarm event. This command allows the user to define the alarm event associated with each channel. Format config external_alarm {unit < unit_id>} channel message Parameters unit - Specifies the unit to display. - Specifies the switch in the switch stack. channel - Specifies which channel is selected to configure. - Enter the value of the channel number to be used here. message - Alarm messages to display on console, log and trap. - Enter up to 128 characters here for the message to be displayed. Restrictions Only Administrator, Operator and Power-User level users can issue this command. Example To configure an alarm message for channel 1 of unit 2: DGS-3620-28SC:admin# config external_alarm unit 2 channel 1 message External Alarm: UPS is exhausted! Command: config external_alarm unit 2 channel 1 message External Alarm: UPS is exhausted! Success. DGS-3620-28SC:admin# 421