D-Link DGS-3620-52T CLI Guide - Page 276

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide Format debug output [module | all] [buffer | console] Parameters module - Specifies the module list. - Enter the module list here. all - Control output method of all modules. buffer - Direct the debug message of the module output to debug buffer(default). console - Direct the debug message of the module output to local console. Restrictions Only Administrator level users can issue this command. Example To set all module debug message outputs to local console: DGS-3620-28SC:admin# debug output all console Command: debug output all console Success. DGS-3620-28SC:admin# 20-6 debug config error_reboot Description This command is used to set if the switch needs to be rebooted when a fatal error occurs. When the error occurs, the watchdog timer will be disabled by the system first, and then all debug information will be saved in NVRAM. If the error_reboot is enabled, the watchdog shall be enabled after all information is stored into NVRAM. Format debug config error_reboot [enable | disable] Parameters enable - Need reboot switch when fatal error happens.(if the project do not define the default setting, enable for default). disable - Do not need reboot switch when fatal error happens, system will hang-up for debug and enter the debug shell mode for debug. Restrictions Only Administrator level users can issue this command. 271