D-Link DGS-3620-52T CLI Guide - Page 1104

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide Parameters None. Restrictions Only Administrator, Operator and Power-User level users can issue this command. Example To clear the WAC default redirect path: DGS-3620-28SC:admin#config wac clear_default_redirpath Success. DGS-3620-28SC:admin# 108-8 config wac virtual_ip Description This command is used to configure the WAC virtual IP address. When virtual IP is specified, the TCP packets sent to the virtual IP will get a reply. If virtual IP is enabled, TCP packets sent to the virtual IP or physical IPIF's IP address will both get the reply. When virtual IP is set 0.0.0.0, the virtual IP will be disabled. By default, the virtual IP is 0.0.0.0. The virtual IP will not respond to any ARP requests or ICMP packets. To make this function work properly, the virtual IP should not be an existing IP address. It also cannot be located on an existing subnet. Format config wac virtual_ip { | } Parameters - Specifies the IPv4 address of the virtual IP. - Specifies the IPv6 address of the virtual IP. Restrictions Only Administrator, Operator and Power-User level users can issue this command. Example To configure the WAC virtual IP address used to accept authentication requests from unauthenticated hosts: DGS-3620-28SC:admin# config wac virtual_ip 1.1.1.1 Command: config wac virtual_ip 1.1.1.1 Success. DGS-3620-28SC:admin# 1099