D-Link DGS-3620-52T CLI Guide - Page 728
config snmp warmstart_traps, config trap source_ipif
View all D-Link DGS-3620-52T manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 728 highlights
xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide Success. DGS-3620-28SC:admin# 66-19 config snmp warmstart_traps Description This command is used to configure the trap state for warmstart events. Format config snmp warmstart_traps [enable | disable] Parameters enable - Enable traps for warmstart events. The default state is enabled. disable - Disable traps for warmstart events. Restrictions Only Administrator and Operator-level users can issue this command. Example To enable traps for warmstart events: DGS-3620-28SC:admin#config snmp warmstart_traps enable Command: config snmp warmstart_traps enable Success. DGS-3620-28SC:admin# 66-20 config trap source_ipif Description This command is used to force change the ipif information in trap messages. By default, trap messages will carry the information of the ipif they belong to. Format config trap source_ipif [ { | } | none] Parameters - Specify the IP interface name. If only this parameter is specified, the IPv4 address and the smallest IPv6 address of ipif_name will be used as source IP addresses. - (Optional) Specify the IPv4 address. - (Optional) Specify the IPv6 address. none - Specify to clear the configured source IP interface. 723