D-Link DGS-3620-52T CLI Guide - Page 416
show duld ports
View all D-Link DGS-3620-52T manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 416 highlights
xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide Example To enable unidirectional link detection on port 1: DGS-3620-28SC:admin# config duld ports 1 state enable Commands: config duld ports 1 state enable Success DGS-3620-28SC:admin# 30-2 show duld ports Description This command is used to show unidirectional link detection information. Format show duld ports {} Parameters ports - (Optional) Specify a range of ports to be display. - Enter the list of ports to be displayed here. If no ports are specified, all the ports will be displayed. Restrictions None. Example To show ports 1-4 unidirectional link detection information: DGS-3620-28SC:admin#config duld ports 1,2,4 state enable Commands: config duld ports 1,2,4 state enable Success DGS-3620-28SC:admin#show duld ports 1-4 Commands: show duld ports 1-4 port Admin State Time(Sec) 1 Enabled 2 Enabled 3 Enabled 4 Disabled 5 Enabled Oper Status ----------- Enabled Enabled Enabled Disabled Enabled Mode ---------- Shutdown Normal Normal Normal Normal Link Status Discovery ------------ Bidirectional 5 RX Fault 5 TX Fault 5 Unknown 5 Link Down 5 DGS-3620-28SC:admin# 411