D-Link DGS-3620-52T CLI Guide - Page 341

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide Chapter 22 DHCP Relay Commands config dhcp_relay {hops | time }(1) config dhcp_relay add ipif config dhcp_relay delete ipif config dhcp_relay option_60 add string relay [exact-match | partial- match] config dhcp_relay option_60 default [relay | mode [relay | drop]] config dhcp_relay option_60 delete [string {relay } | ipaddress | all | default {}] config dhcp_relay option_60 state [enable | disable] config dhcp_relay option_61 add [mac_address | string ] [relay | drop] config dhcp_relay option_61 default [relay | drop] config dhcp_relay option_61 delete [mac_address | string | all] config dhcp_relay option_61 state [enable | disable] config dhcp_relay option_82 check [enable | disable] config dhcp_relay option_82 policy [replace | drop | keep] config dhcp_relay option_82 remote_id [default | user_define ] config dhcp_relay option_82 state [enable | disable] enable dhcp_relay disable dhcp_relay show dhcp_relay {ipif } show dhcp_relay option_60 {[string | ipaddress | default]} show dhcp_relay option_61 Note: The DHCP relay commands include all the commands defined in the BOOTP relay command section. If this DHCP relay command set is supported in your system, the BOOTP relay commands can be ignored. Note: The system supporting DHCP relay will accept BOOTP relay commands in the config file but not allow input from the console screen, and these BOOTP relay commands setting from the config file will be saved as DHCP relay commands while the save command is performed. 22-1 config dhcp_relay Description This command is used to configure the DHCP relay feature of the switch. Format config dhcp_relay {hops | time }(1) 336