D-Link DGS-3620-52T CLI Guide - Page 377
config dhcpv6_relay, config dhcpv6_relay ipif
View all D-Link DGS-3620-52T manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 377 highlights
xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide 24-4 config dhcpv6_relay Description The command could add/delete an IPv6 address which is a destination to forward (relay) DHCPv6 packets. Format config dhcpv6_relay [add | delete] ipif Parameters add - Add an IPv6 destination to the DHCPv6 relay table. delete - Delete an IPv6 destination from the DHCPv6 relay table ipif - The name of the IP interface in which DHCPv6 relay is to be enabled. - Enter the IP interface name here. This name can be up to 12 characters long. - The DHCPv6 server IP address. Restrictions Only Administrator, Operator and Power-User level users can issue this command. Example To add a DHCPv6 server to the relay table: DGS-3620-28SC:admin# config dhcpv6_relay add ipif System 2001:DB8:1234:0:218:FEFF:FEFB:CC0E Command: config dhcpv6_relay add ipif System 2001:DB8:1234:0:218:FEFF:FEFB:CC0E Success. DGS-3620-28SC:admin# 24-5 config dhcpv6_relay ipif Description The command is used to configure the DHCPv6 relay state of one specific interface or all interfaces. Format config dhcpv6_relay ipif [ | all] state [enable | disable] Parameters ipif - Specifies the name of the IP interface. - Enter the IP interface name used here. This name can be up to 12 characters long. all - Specifies that all the configured IP interfaces wil be used.. state - Specifies if the DHCPv6 relay state will be enabled or disabled. 372