D-Link DGS-3620-52T CLI Guide - Page 525

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide Parameters - (Optional) Enter the IP tunnel interface name used here. This name can be up to 12 characters long. Restrictions None. (EI Mode Only Command) Example To show an IP tunnel interface's information (Tunnel name is "tn2"): DGS-3620-28SC:admin# show ip_tunnel tn2 Command: show ip_tunnel tn2 Tunnel Interface Interface Admin State Tunnel Mode IPv6 Address Tunnel Source Tunnel Destination : tn2 : Enabled : Manual : 2000::1/64 : 1.0.0.1 : 1.0.0.2 DGS-3620-28SC:admin# 44-7 enable ip_tunnel Description This command is used to enable a single specified IP tunnel or all IP tunnels on the Switch. Format enable ip_tunnel {} Parameters - (Optional) Enter the IP tunnel interface name used here. This name can be up to 12 characters long. Restrictions Only Administrator, Operator and Power-User level users can issue this command. (EI Mode Only Command) Example To enable an IP tunnel interface (Tunnel name is "tn2"): 520