D-Link DGS-3620-52T CLI Guide - Page 806
enable pim
View all D-Link DGS-3620-52T manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 806 highlights
xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide hello - (Optional) Specifies the time between issuing hello packets to find neighboring routers. - Enter the hello time value here. This value must be between 1 and 18724 seconds. The default value is 30 seconds. jp_interval - (Optional) Specifies the interval between transmitting (flooding to all interfaces) multicast messages to downstream routers, and automatically 'pruning' a branch from the multicast delivery tree. This interval also determines the time interval the router uses to automatically remove prune information from a branch of a multicast delivery tree and begin to flood multicast messages to all branches of that delivery tree. These two actions are equivalent. The default is 60 seconds. - Enter the join/prune interval value here. This value must be between 1 and 18724 seconds. state - (Optional) Specifies to allow the PIM function to be disabled or enabled for the above IP interface. The default is disabled. enable - Specifies that the PIM function will be enabled. disable - Specifies that the PIM function will be disabled. mode - (Optional) Specifies the multicast protocol mode used. - dense mode or sparse mode, or sm-dm mode. The default value is dense mode. dm - Specifies that the multicast protocol mode will be set to dense mode. sm - Specifies that the multicast protocol mode will be set to sparse mode. sm-dm - Specifies that the multicast protocol mode will be set to both dense and sparse mode. dr_priority - (Optional) Specifies the priority for DR election. - Enter the DR priority value used here. This value must be between 0 and 4294967294. register_probe_time - Specifies the register probe time. The default value is 5 sec. - Enter the register probe time value here. This value must be between 1 and 127. register_suppression_time - Specifies the register supression time. The default value is 60 sec. - Enter the register suppression time value here. This value must be between 3 and 255. Restrictions Only Administrator, Operator and Power-User level users can issue this command. Example To configure PIM configurations of IP interface System: DGS-3620-28SC:admin# config pim ipif System hello 35 jp_interval 70 state enable Command: config pim ipif System hello 35 jp_interval 70 state enable Success. DGS-3620-28SC:admin# 73-2 enable pim Description This command is used to enable PIM on the switch. Format enable pim 801