D-Link DGS-3620-52T CLI Guide - Page 521
delete ip_tunnel, config ip_tunnel manual
View all D-Link DGS-3620-52T manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 521 highlights
xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide 44-2 delete ip_tunnel Description This command is used to delete an IP tunnel interface. Format delete ip_tunnel Parameters - Enter the IP tunnel interface name used here. This name can be up to 12 characters long. Restrictions Only Administrator, Operator and Power-User level users can issue this command. (EI Mode Only Command) Example To delete an IP tunnel interface (with the tunnel name "tn2"): DGS-3620-28SC:admin# delete ip_tunnel tn2 Command: delete ip_tunnel tunnel tn2 Success. DGS-3620-28SC:admin# 44-3 config ip_tunnel manual Description This command is used to configure an IPv6 manual tunnel. If this tunnel has previously been configured in another mode, the tunnel's information will still exist in the database. However, whether the tunnel's former information is invalid or not, will depend on the current mode. IPv6 Manual tunnels are simple point-to-point tunnels that can be used within a site or between sites. Format config ip_tunnel manual {ipv6address | source | destination }(1) Parameters - Enter the IP tunnel interface name used here. This name can be up to 12 characters long. ipv6address - (Optional) Specifies the IPv6 address assigned to the IPv6 tunnel interface. IPv6 processing becomes enabled on the IPv6 tunnel interface when an IPv6 address is 516