D-Link DGS-3620-52T CLI Guide - Page 516
show ipv6route
View all D-Link DGS-3620-52T manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 516 highlights
xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide ip_tunnel - Specifies the IPv6 tunnel name used. (EI Mode Only Parameter) - Enter the IPv6 tunnel name used here. This name can be up to 12 characters long. all - All created static routes will be deleted. Restrictions Only Administrator, Operator and Power-User level users can issue this command. Example To delete an IPv6 static route: DGS-3620-28SC:admin#delete ipv6route default System FEC0::5 Command: delete ipv6route default System FEC0::5 Success. DGS-3620-28SC:admin# 43-6 show ipv6route Description This command is used to display the switch's current IPv6 routing table. Format show ipv6route {[ | ]} {[static | ripng | ospfv3 | hardware]} Parameters - (Optional) Specifies the IPv6 destination network address of the route. - (Optional) Specifies the IPv6 address. static - (Optional) Specifies the static route entries. ripng - (Optional) Specifies the RIPng route entries. (EI Mode Only Parameter) ospfv3 - (Optional) Specifies the OSPFv3 route entries. (EI Mode Only Parameter) hardware - (Optional) Specifies the route entries which have been written into hardware table. Restrictions None. Example To display an IPv6 route: DGS-3620-28SC:admin#show ipv6route Command: show ipv6route IPv6 Prefix: ::/0 Next Hop : FEC0::5 Protocol: Static Metric: 1 IPIF : System 511