D-Link DGS-3620-52T CLI Guide - Page 449
config filter extensive_netbios
View all D-Link DGS-3620-52T manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 449 highlights
xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide Restrictions None. Example To display the DHCP server/client filter list created on the switch: DGS-3620-28SC:admin#show filter dhcp_server Command: show filter dhcp_server Enabled Ports: 1,28 Trap & Log State: Enabled Illegal Server Log Suppress Duration: 1 minutes Permit DHCP Server/Client Table Server IP Address Client MAC Address Port Total Entries: 0 DGS-3620-28SC:admin# 35-3 config filter extensive_netbios Description This command is used to configure the switch to deny NetBIOS packets over 802.3 frames on the network. Enabling the filterNetBIOS packets over 802.3 frames will create one access profile and one access rule per port automatically. Filter commands in this file will share the same access profile. Format config filter extensive_netbios [ | all] state [enable | disable] Parameters - Specify the port or range of ports to configure. all - Specify to configure all ports. state - Specify the status of the filter to block the NetBIOS packets over 802.3 frames. enable - Enable the filter to block the NetBIOS packets over 802.3 frames. disable - Disable the filter to block the NetBIOS packets over 802.3 frames. Restrictions Only Administrator, Operator and Power-User level users can issue this command. Example To configure the extensive NetBIOS filter state on ports 1 to 10: DGS-3620-28SC:admin#config filter extensive_netbios 1-10 state enable Command: config filter extensive_netbios 1-10 state enable 444