D-Link DGS-3620-52T CLI Guide - Page 1167

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide Appendix D RADIUS Attributes Assignment The RADIUS Attributes Assignment on the Switch is used in the following modules: 802.1X (Portbased and Host-based), Japanese Web-based Access Control, Web-based Access Control, and MAC-based Access Control. The description that follows explains the following RADIUS Attributes Assignment types:  Ingress/Egress Bandwidth  802.1p Default Priority  VLAN  ACL To assign Ingress/Egress bandwidth by RADIUS Server, the proper parameters should be configured on the RADIUS Server. The tables below show the parameters for bandwidth. The parameters of the Vendor-Specific attributes are: Vendor-Specific Attribute Description Value Vendor-ID Defines the vendor. 171 (DLINK) Vendor-Type Defines the attribute. 2 (for ingress bandwidth) 3 (for egress bandwidth) Attribute-Specific Field Used to assign the bandwidth Unit (Kbits) of a port. Usage Required Required Required If the user has configured the bandwidth attribute of the RADIUS server (for example, ingress bandwidth 1000Kbps) and the 802.1X authentication is successful, the device will assign the bandwidth (according to the RADIUS server) to the port. However, if the user does not configure the bandwidth attribute and authenticates successfully, the device will not assign any bandwidth to the port. If the bandwidth attribute is configured on the RADIUS server with a value of "0", the effective bandwidth will be set "no_limited", and if the bandwidth is configured less than "0" or greater than maximum supported value, the bandwidth will be ignored. To assign 802.1p default priority by RADIUS Server, the proper parameters should be configured on the RADIUS Server. The tables below show the parameters for 802.1p default priority. The parameters of the Vendor-Specific attributes are: 1162