D-Link DGS-3620-52T CLI Guide - Page 904
config dscp map
View all D-Link DGS-3620-52T manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 904 highlights
xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide Parameters - A range of ports to display. If not specifying any ports, the DSCP trust status for all ports on the switch will be displayed. Restrictions Only Administrator, Operator level users can issue this command. Example To enable DSCP trust on ports 1:1-1:8: DGS-3620-28SC:admin#show dscp_trust 1:1-1:8 Command: show dscp_trust 1:1-1:8 Port ----1:1 1:2 1:3 1:4 1:5 1:6 1:7 1:8 DSCP-Trust ----------Disabled Disabled Disabled Disabled Enabled Enabled Enabled Enabled DGS-3620-28SC:admin # 81-18 config dscp map Description This command is used to configure the mapping of DSCP to a priority. Format config dscp map [ | all] [ dscp_priority to | dscp_dscp to ] Parameters - A range of ports to display. If not specifying any ports, the DSCP trust status for all ports on the switch will be displayed. all - Specifies that the command applies to all ports on the switch. dscp_priority - Specifies a list of DSCP values to be mapped to a specific priority. - Enter the dscp list number here. - Specifies the result priority of a mapping. dscp_dscp - Specifies a list of DSCP values to be mapped to a specific DSCP. - Enter the dscp list number here. - Specifies the result DSCP of mapping. 899