D-Link DGS-3620-52T CLI Guide - Page 274
debug buffer
View all D-Link DGS-3620-52T manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 274 highlights
xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide ->809E1DEC ->809D7E6C ->80A038CC ->80A033B0 ->80A0297C To clear the error log: DGS-3620-28SC:admin# debug error_log clear Command: debug error_log clear Success. DGS-3620-28SC:admin# To upload the error log to TFTP server: DGS-3620-28SC:admin# debug error_log upload_toTFTP 10.0.0.90 debug-log.txt Command: debug error_log upload_toTFTP 10.0.0.90 debug-log.txt Connecting to server Done. Upload configuration Done. DGS-3620-28SC:admin# 20-4 debug buffer Description Use this command to show the debug buffer's state, or dump, clear, or upload the debug buffer to a TFTP server. Note: When selecting to output to the debug buffer and there are debug messages being outputted, the system memory pool will be used as the debug buffer. The functions which will use the system memory pool resource may fail to execute command such as download and upload firmware, or save configuration. If you want to execute these commands successfully, please use the command "debug buffer clear" to release the system's memory pool resources manually first. Format debug buffer [utilization | dump | clear | upload_toTFTP ] Parameters utilization - Display the debug buffer's state. dump - Display the debug message in the debug buffer. clear - Clear the debug buffer. upload_toTFTP - Upload the debug buffer to a TFTP server specified by IP address. - Specifies the IPv4 address of the TFTP server. - The pathname specifies the DOS pathname on the TFTP server. It can be a relative pathname or an absolute pathname. This value can be up to 64 characters 269