D-Link DGS-3620-52T CLI Guide - Page 743
state [enable | disable]} 1
View all D-Link DGS-3620-52T manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 743 highlights
xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide local5 | local6 | local7] | udp_port | ipaddress[ | ] | state [enable | disable]} (1) Parameters - Specify the host index. all - Specify all hosts. severity - (Optional) Specify the severity level supported: emergency, alert, critical, error, warning, notice, informational, or debug. emergency - Specify emergency messages. alert - Specify alert messages. critical - Specify critical messages. error - Specify error messages. warning - Specify warning messages. notice - Specify notice messages. informational - Specify informational messages. debug - Specify debug messages. - Specify a level between 0 and 7. facility - Some of the operating system daemons and processes have been assigned facility values. Processes and daemons that have not been explicitly assigned a facility may use any of the"local use" facilities or they may use the "user-level" facility. Those facilities that have been designated are shown in the following: local0 - User-defined facility. local1 - User-defined facility. local2 - User-defined facility. local3 - User-defined facility. local4 - User-defined facility. local5 - User-defined facility. local6 - User-defined facility. local7 - User-defined facility. udp_port - Specify the UDP port number. - Specify the UDP port number. ipaddress - Specify the IPv4 address or IPv6 address of the host. - Specify the IPv4 address of the host. - Specify the IPv6 address of the host. state - The syslog protocol has been used for the transmission of event notification messages across networks to host. This option enables or disables the host to receive such messages. enable - Enable the host to receive messages. disable - Disable the host to receive messages. Restrictions Only Administrator and Operator-level users can issue this command. Example To configure the syslog host configuration: DGS-3620-28SC:admin# config syslog host all severity informational facility local0 Command: config syslog host all severity informational facility local0 Success. DGS-3620-28SC:admin# 738