D-Link DGS-3620-52T CLI Guide - Page 565

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide 47-11 config jwac quarantine_server_error_timeout Description This command is used to set the quarantine server error timeout. When the quarantine server monitor is enabled, the JWAC switch will periodically check if the quarantine works okay. If the switch does not receive any response from quarantine server during the configured error timeout, the switch then regards it as not working properly. Format config jwac quarantine_server_error_timeout Parameters - Specify the error timeout interval. Restrictions Only Administrator, Operator and Power-User level users can issue this command. Example To set the quarantine server error timeout: DGS-3620-28SC:admin#config jwac quarantine_server_error_timeout 60 Command: config jwac quarantine_server_error_timeout 60 Success. DGS-3620-28SC:admin# 47-12 config jwac Description This command is used to configure the quarantine server URL. If the redirection is enabled and the redirection destination is a quarantine server, when a HTTP request from an unauthenticated host which is not headed to a quarantine server reaches the Switch, the Switch will handle this HTTP packet and send back a message to the host to make it access the quarantine server with the configured URL. When the PC connected to the specified URL, the quarantine server will request the PC user to input the user name and password to authenticate. Note: If the quarantine server is linked to the JWAC enabled port on the switch, it must be added to the static FDB correctly before it can work properly. Format config jwac [quarantine_server_url | clear_quarantine_server_url] 560