D-Link DGS-3620-52T CLI Guide - Page 508

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide Format config route_map [[add | delete] sequence {[deny | permit]} | sequence [match [add | delete] [as_path | community_list {exact} | ip [next_hop | address] {prefix_list} | metric ] | set [add | delete] [next_hop [ | peer_address] | metric | local_preference | weight | as_path | community {community_set | internet | no_export | no_advertise | local_as} {additive} | origin [egp | igp | incomplete] | dampening ]]] Parameters - Enter the route map name used here. This name can be up to 16 characters long. add - Specifies to add a sequence entry. delete - Specifies to remove a sequence entry. sequence - Specifies the sequence number for the route map rule. - Enter the sequence number used here. This value must be between 1 and 65535. deny - (Optional) Specifies to deny the route if the rule is matched. permit - (Optional) Specifies to permit the route if the rule is matched. sequence - Specifies the sequence number for the route map rule. - Enter the sequence number used here. This value must be between 1 and 65535. match - Specifies to check if the sequence entry matches. add - Specifies the entry or the set to add. delete - Specifies the entry or the set to delete. as_path - Specifies to match the AS path of the route against the AS path list. The AS path list specified here needs to be a sub-list of the AS path list associated with the route. - Enter the AS path name used here. This name can be up to 16 characters long. community_list - Specifies to match the community of the route against the community string. - Enter the community list name used here. This name can be up to 16 characters long. exact - (Optional) Specifies that all of the communities and only those communities specified must be present. ip - Specifies to match the route according to the access list. next_hop - Specifies to match the next hop of the route according to the access list. address - Specifies to match the route according to the access list. prefix_list - (Optional) Specifies to match the route according to the prefix list. - Enter the prefix list name used here. This name can be up to 16 characters long. metric - Specifies to match the metric of the route. - Enter the metric value used here. This value must be between 0 and 4294967294. set - Specifies to define the conditions for redistributing routes from one routing protocol into another. add - Specifies the set to add. delete - Specifies the set to delete. next_hop - Specifies the next hop attribute. - Specifies the IP address to set. peer_address - This will take effect for both the ingress and egress directions. When set to next_hop to peer address, for ingress direction, the next hop will be set to the neighbor peer address. For egress direction, the next hop associated with the route in the packet will be the neighbor peer address. metric - Specifies to set the metric. - Enter the metric value used here. This value must be between 0 and 503