D-Link DGS-3620-52T CLI Guide - Page 614

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide advertisements. dot3_tlvs - An individual port or group of ports to exclude one or more of IEEE 802.3 Organizationally Specific TLV data types from outbound LLDP advertisements. all - (Optional) Configure all of the TLV optional data types below. mac_phy_configuration_status - (Optional) This TLV optional data type indicates that LLDP agent should transmit "MAC/PHY configuration/status TLV." This type indicates it is possible for two ends of an IEEE 802.3 link to be configured with different duplex and/or speed settings and still establish some limited network connectivity. More precisely, the information includes whether the port supports the auto-negotiation function, whether the function is enabled, the auto-negotiated advertised capability, and the operational MAU type. The default state is disabled. link_aggregation - (Optional) This TLV optional data type indicates that LLDP agent should transmit "Link Aggregation TLV." This type indicates the current link aggregation status of IEEE 802.3 MACs. More precisely, the information should include whether the port is capable of doing link aggregation, whether the port is aggregated in an aggregated link, and the aggregated port ID. The default state is disabled. power_via_mdi - (Optional) This TLV optional data type indicates that LLDP agent should transmit 'Power via MDI TLV'. The default state is disabled. maximum_frame_size - (Optional) This TLV optional data type indicates that LLDP agent should transmit "Maximum-frame-size TLV." The default state is disabled. enable - Enable the configuration of an individual port or group of ports to exclude one or more of IEEE 802.3 Organizationally Specific TLV data types from outbound LLDP advertisements. disable - Disable the configuration of an individual port or group of ports to exclude one or more of IEEE 802.3 Organizationally Specific TLV data types from outbound LLDP advertisements. Restrictions Only Administrator, Operator and Power-User level users can issue this command. Example To change the SNMP notification state of ports 1 to 5 to enable: DGS-3620-28SC:admin#config lldp ports 1-5 notification enable Command: config lldp ports 1-5 notification enable Success. DGS-3620-28SC:admin# To configure the mode of ports 1 to 5 to transmit and receive: DGS-3620-28SC:admin#config lldp ports 1-5 admin_status tx_and_rx Command: config lldp ports 1-5 admin_status tx_and_rx Success. DGS-3620-28SC:admin# To enable ports 1 to 5 to manage address entries: DGS-3620-28SC:admin#config lldp ports 1-5 mgt_addr ipv4 192.168.254.10 enable Command: config lldp ports 1-5 mgt_addr ipv4 192.168.254.10 enable 609