D-Link DGS-3620-52T CLI Guide - Page 923
config ripng ipif
View all D-Link DGS-3620-52T manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 923 highlights
xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide DGS-3620-28SC:admin# config ripng method poison_reverse Command: config ripng method poison_reverse Success. DGS-3620-28SC:admin# 84-5 config ripng ipif Description This command is used to specify the RIPng state and metric value for one or all interfaces Format config ripng ipif [ | all] {state [enable | disable] | metric } (1) Parameters ipif - Specifies the RIPng IP interface name to be configured. - Enter the RIPng IP interface name to be configured here. This name can be up to 12 characters long. all - Specifies that all the RIPng IP interfaces will be used. state - (Optional) Specifies the RIPng state of the specifies IP interface. enable - Specifies that the RIPng state on the specified interface will be enabled. disable - Specifies that the RIPng state on the specified interface will be disabled. metric - (Optional) Specifies the cost value of an interface. The RIPng route that was learned from the interface will add this value as a new route metric. - Enter the metric value used here. This value must be between 1 and 15. The default value is 1. Restrictions Only Administrator, Operator and Power-User level users can issue this command. (EI Mode Only Command) Example To enable the RIPng interface state: DGS-3620-28SC:admin# config ripng ipif System state enable Command: config ripng ipif System state enable Success. DGS-3620-28SC:admin# 918