D-Link DGS-3620-52T CLI Guide - Page 360

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide 23-6 config dhcp pool network_addr Description This command is used to specify the network for the DHCP pool. The addresses in the network are free to be assigned to the DHCP client. The prefix length specifies the number of bits that comprise the address prefix. The prefix is an alternative way of specifying the network mask of the client. The prefix length must be preceded by a forward slash (/). When the DHCP server receives a request from the client, the server will automatically find a pool to allocate the address. If the request is relayed to the server by the intermediate device, the server will match the gateway IP address carried in the packet against the network of each DHCP pool. The pool which has the longest match will be selected. If the request packet is not through relay, then the server will match the IP address of the IPIF that received the request packet against the network of each DHCP pool. Format config dhcp pool network_addr Parameters - Specify the DHCP pool name. - Specify the IP address that the DHCP server may assign to clients. Restrictions Only Administrator, Operator and Power-User level users can issue this command. Example To configure the address range of the DHCP address pool: DGS-3620-28SC:admin#config dhcp pool network_addr nyknicks 10.10.10.0/24 Command: config dhcp pool network_addr nyknicks 10.10.10.0/24 Success. DGS-3620-28SC:admin# 23-7 config dhcp pool domain_name Description This command is used to specify the domain name for the client if the server allocates the address for the client from this pool. The domain name configured here will be used as the default domain name by the client. By default, the domain name is empty. If the domain name is empty, the domain name information will not be provided to the client. Format config dhcp pool domain_name {} 355