D-Link DGS-3620-52T CLI Guide - Page 356

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide Chapter 23 DHCP Server Commands create dhcp excluded_address begin_address end_address delete dhcp excluded_address [begin_address end_address | all] show dhcp excluded_address create dhcp pool delete dhcp pool [ | all] config dhcp pool network_addr config dhcp pool domain_name {} config dhcp pool dns_server {} {} {} config dhcp pool netbios_name_server {} {} {} config dhcp pool netbios_node_type [broadcast | peer_to_peer | mixed | hybrid] config dhcp pool default_router {} {} {} config dhcp pool lease [ | infinite] config dhcp pool boot_file {} config dhcp pool next_server {} config dhcp ping_packets config dhcp ping_timeout create dhcp pool manual_binding hardware_address {type [ethernet | ieee802]} delete dhcp pool manual_binding [ | all] clear dhcp binding [ [ | all] | all] show dhcp binding {} show dhcp pool {} show dhcp pool manual_binding {} enable dhcp_server disable dhcp_server show dhcp_server clear dhcp conflict_ip [ | all] show dhcp conflict_ip {} 23-1 create dhcp excluded_address Description This command is used to create a DHCP server exclude address. The DHCP server assumes that all IP addresses in a DHCP pool subnet are available for assigning to DHCP clients. Use this command to specify the IP address that the DHCP server should not assign to clients. This command can be used multiple times in order to define multiple groups of excluded addresses. Format create dhcp excluded_address begin_address end_address Parameters begin_address - Specify the starting address of the IP address range. - Specify the starting address of the IP address range. 351