D-Link DGS-3620-52T CLI Guide - Page 790
show ospfv3 virtual_neighbor
View all D-Link DGS-3620-52T manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 790 highlights
xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide Parameters - (Optional) Specifies the ID of the neighbor. ipif - (Optional) Specifies the IP interface where the neighbor is built. - Enter the IP interface name used here. This name can be up to 12 characters long. Restrictions None. (EI Mode Only Command) Example To display OSPFv3 neighbor: DGS-3620-28SC:admin# show ospfv3 neighbor Command: show ospfv3 neighbor Router ID of Interface Neighbor Neighbor Neighbor Name Priority State 10.10.10.10 System 1 Full 20.20.20.20 ip1 10 Full Total Entries: 2 DGS-3620-28SC:admin# show ospfv3 neighbor 10.10.10.10 ipif System Command: show ospfv3 neighbor 10.10.10.10 ipif System Neighbor ID: 10.10.10.10 Neighbor Options: 19 Neighbor State: Full Interface ID: 1 Interface Name: System Neighbor Priority: 255 State Changes: 6 times DGS-3620-28SC:admin# 70-15 show ospfv3 virtual_neighbor Description This command is used to display OSPFv3 virtual neighbor information. Format show ospfv3 virtual_neighbor { } Parameters - (Optional) Specifies the transit area where the virtual neighbor is built. - (Optional) Specifies the ID of the virtual neighbor. If none of the parameters are set, all the virtual neighbors will be displayed. 785