D-Link DGS-3620-52T CLI Guide - Page 824
show pim6
View all D-Link DGS-3620-52T manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 824 highlights
xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide Success. DGS-3620-28SC:admin# 74-2 show pim6 Description This command is used to display the PIM6 configurations. Format show pim6 {ipif } Parameters ipif - (Optional) Specifies the IP interface to be displayed. - Enter the IP interface name used here. This name can be up to 12 characters long. If no parameter is specified, the system will display the PIM6 parameters on all IPv6 interfaces in brief. Restrictions None. (EI Mode Only Command) Example To show the brief info of the PIM6 protocol concerned parameters on all interfaces: DGS-3620-28SC:admin# show pim6 Command: show pim6 PIM6 Global State Last Hop SPT Switchover Register Probe Interval Register Suppression Timeout Keepalive Period Register Checksum Calculate Embedded RP State : Enabled : Immediately : 5 sec : 60 sec : 210 sec : Include Data : Disabled PIM6-SM Interface Table Interface ---------System DR Priority -------1 Hello Interval -------3 J/P Interval --------60 State --------Disabled BSR Border -------Disabled Total Entries : 1 DGS-3620-28SC:admin# 819