D-Link DGS-3620-52T CLI Guide - Page 759
create ospf aggregation
View all D-Link DGS-3620-52T manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 759 highlights
xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide DGS-3620-28SC:admin# config ospf ipif System priority 2 hello_interval 20 metric 2 state enabled Command: config ospf ipif System priority 2 hello_interval 20 metric 2 state enabled Success. DGS-3620-28SC:admin# 69-2 create ospf aggregation Description This command is used to create an OSPF area aggregation entry. Format create ospf aggregation lsdb_type [summary {advertise [enable | disable]} | nssa_ext {advertise [enable | disable]}] Parameters - A 32-bit number in the form of an IP address (xxx.xxx.xxx.xxx) that uniquely identifies the OSPF area in the OSPF domain. - The IP address that uniquely identifies the network that corresponds to the OSPF Area. The network address format is 'IP address/prefix length'. lsdb_type - Specifies the Link-State Database (LSDB) type of address aggregation. summary - Specifies the LSDB type as summary. advertise - (Optional) Allows for the advertisement of the summary LSDB. enable - Specifies that the advertisement trigger will be enabled. disable - Specifies that the advertisement trigger will be disabled. nssa_ext - Specifies the LSDB type as a Not-So-Stub Area External Route (NSSA EXT). advertise - (Optional) Allows for the advertisement of aggregated NSSA external route. enable - Specifies that the advertisement trigger will be enabled. disable - Specifies that the advertisement trigger will be disabled. Restrictions Only Administrator, Operator and Power-User level users can issue this command. Example To create OSPF area aggregation settings: DGS-3620-28SC:admin# create ospf aggregation 10.1.1.1 192.168.0.0/16 lsdb_type summary Command: create ospf aggresgation 10.1.1.1 192.168.0.0/16 lsdb_type summary Success. DGS-3620-28SC:admin# 754