D-Link DGS-3620-52T CLI Guide - Page 617
config lldp_med fast_start repeat_count
View all D-Link DGS-3620-52T manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 617 highlights
xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide DGS-3620-28SC:admin#show lldp ports 1 Command: show lldp ports 1 Port ID : 1 Admin Status : TX_and_RX Notification Status : Disabled Advertised TLVs Option : Port Description Disabled System Name Disabled System Description Disabled System Capabilities Disabled Enabled Management Address (None) Port VLAN ID Disabled Enabled Port_and_Protocol_VLAN_ID (None) Enabled VLAN Name (None) Enabled Protocol Identity (None) MAC/PHY Configuration/Status Disabled Link Aggregation Disabled Maximum Frame Size Disabled DGS-3620-28SC:admin# 53-9 config lldp_med fast_start repeat_count Description This command is used to configure the fast start repeat count. When an LLDP-MED Capabilities TLV is detected for an MSAP identifier not associated with an existing LLDP remote system MIB, the application layer shall start the fast start mechanism and set the 'medFastStart' timer to 'medFastStartRepeatCount' times 1. The default value is 4. Format config lldp_med fast_start repeat_count Parameters - Specify a fast start repeat count value between 1 and 10. The default value is 4. Restrictions Only Administrator and Operator-level users can issue this command. Example To configure a LLDP-MED fast start repeat count of 5: 612