D-Link DGS-3620-52T CLI Guide - Page 512
IP Routing, Commands
View all D-Link DGS-3620-52T manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 512 highlights
xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide Chapter 43 IP Routing Commands create iproute [default | ] [null0 | {} {[primary | backup | weight ]} | ip_tunnel ] delete iproute [default | ] [null0 | | ip_tunnel ] show iproute {[ | ]} {[static | rip | ospf | bgp | hardware]} create ipv6route [default | ] [[ | ] {} {[primary | backup]} | ip_tunnel ] delete ipv6route [[default | ] [ | | ip_tunnel ] | all] show ipv6route {[ | ]} {[static | ripng | ospfv3 | hardware]} enable ecmp ospf disable ecmp ospf config ecmp algorithm {ip_destination | [ip_source| crc_low | crc_high] | tcp_udp_port} (1) show ecmp algorithm 43-1 create iproute Description This command is used to create an IP route entry in the switch's IP routing table. "Primary" and "backup" are mutually exclusive. Users can select only one when creating one new route. If a user sets neither of these, the system will try to set the new route first by primary and second by backup and not set this route to be a multipath route. Format create iproute [default | ] [null0 | {} {[primary | backup | weight ]} | ip_tunnel ] Parameters default - Specifies to create a default IP route entry. - The IP address and netmask of the IP interface that is the destination of the route. Specifies the address and mask information using the traditional format (for example, 10.1.2.3/255.0.0.0 or in CIDR format, 10.1.2.3/8). null0 - Specifies the null interface as the next hop. - Specifies the IP address for the next hop router. - (Optional) The default setting is 1.That is, the default hop cost is 1. primary - (Optional) Specifies the route as the primary route to the destination. backup - (Optional) Specifies the route as the backup route to the destination. If the route is not specified as the primary route or the backup route, then it will be auto-assigned by the system. The first created is the primary, the second created is the backup. weight - (Optional) Specifies the weight value of the IP route. - Enter the weight value used here. This value must be between 1 and 4. ip_tunnel - Specifies the IP tunnel used. (EI Mode Only Parameter) - Enter the IP tunnel name used here. This name can be up to 12 characters long. 507