D-Link DGS-3620-52T CLI Guide - Page 791
config ospfv3
View all D-Link DGS-3620-52T manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 791 highlights
xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide Restrictions None. (EI Mode Only Command) Example To display OSPFv3 virtual neighbor: DGS-3620-28SC:admin# show ospfv3 virtual_neighbor Command: show ospfv3 virtual_neighbor Transit Router ID Of Virtual Neighbor Area ID Virtual Neighbor State 1.1.1.1 30.30.30.30 Full Total Entries: 1 DGS-3620-28SC:admin# show ospfv3 virtual_neighbor 6.6.6.6 20.20.20.20 Command: show ospfv3 virtual_neighbor 6.6.6.6 20.20.20.20 Transit Area ID: 6.6.6.6 Virtual Neighbor ID: 20.20.20.20 Virtual Neighbor Options: 19 Virtual Neighbor State: Full State Changes: 9 times Total Entries: 1 DGS-3620-28SC:admin# 70-16 config ospfv3 Description This command is used to configure an OSPFv3 interface. Format config ospfv3 [ipif | all] {area | priority | hello_interval | dead_interval | instance | metric | state [enable | disable] | passive [enable | disable]} (1) Parameters ipif - Specifies the OSPFv3 IP interface name used. - Enter the OSPFv3 IP interface name used here. This name can be up to 12 characters long. all - Specifies that all the OSPFv3 IP interfaces will be used. area - (Optional) Specifies a 32-bit number in the form of an IPv4 address that uniquely identifies the OSPFv3 area in the OSPFv3 domain. - Enter the area ID used here. priority - (Optional) Specifies the priority used in the election of the Designated Router (DR). - Enter the priority value used here. This value must be between 0 and 255. The default value is 1. 786