D-Link DGS-3620-52T CLI Guide - Page 163
config bgp timer
View all D-Link DGS-3620-52T manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 163 highlights
xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide Restrictions None. (EI Mode Only Command) Example To show network 10.108.0.0/16 advertised in the BGP updates: DGS-3620-28SC:admin# show bgp network 10.108.0.0/16 Command: show bgp network 10.108.0.0/16 Network Address 10.108.0.0/16 Route Map - Total Network Number: 1 DGS-3620-28SC:admin# 12-15 config bgp timer Description This command is used to configure the BGP protocol timer. The hold time needs to be at least three times that of the keepalive time. If the timer is specified for specific neighbors, then the neighbor specific timer will take effect. Format config bgp timer holdtime keepalive Parameters holdtime - The system will declare a peer as dead if a keepalive message is received that is more than the hold time. The default value is 180 seconds. If the holdtime is set to zero, then the holdtime will never expire. If the two routers that build a BGP connection have a different hold time, then the smaller hold time will be used. If the timer is specified for specific neighbors, then the neighbor specific timer will take effect. The hold time needs to be at least three times that of the keepalive timer. - Enter the hold time value used here. This value must be between 0 and 65535. keepalive - This specifies the interval at which keepalive messages are sent to its peer. If the keepalive value is set to zero, then the keepalive message will not be sent out. The default value is 60 seconds. If the two routers that build a BGP connection have a different keepalive timer, then the smaller keepalive timer will be used. If the timer is specified for specific neighbors, then the neighbor specific timer will take effect. - Enter the keep-alive time value used here. This value must be between 0 and 65535. Restrictions Only Administrator, Operator and Power-User level users can issue this command. (EI Mode Only Command) 158