D-Link DGS-3620-52T CLI Guide - Page 185

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide Parameters peers - Specifies that a peer will be added or deleted. add - Specifies that a peer will be added. delete - Specifies that a peer will be deleted. - Enter the AS number for BGP peers that will belong to the confederation here. Restrictions Only Administrator, Operator and Power-User level users can issue this command. (EI Mode Only Command) Example To add two confederation peers, AS number are 50000 and 50001: DGS-3620-28SC:admin# config bgp confederation peers add 50000, 50001 Command: config bgp confederation peers add 50000, 50001 Success. DGS-3620-28SC:admin# 12-34 clear bgp Description This command is used to initiate a hard reset or a soft reset for a connection. If a hard reset is applied to the inbound session, the inbound session will be teared down and the local inbound routing table and the remote outbound routing table will be cleared. If a soft reset is applied to the inbound session, the session will not be rebuilded but the local inbound routing table will be cleared and needs to be rebuilt. If a soft reconfiguration inbound is enabled, then the routing table can be rebuilt based on the stored route updates information. If a soft reconfiguration inbound is disabled, then the local router will send the route refresh request to the neighbor to ask for the route refresh. When the inbound session is to soft reset with the prefix filter option, and capability_orf_prefix_list is enabled in the send direction, then the local BGP will send 'clear the routing table', and notify the remote neighbor for the prefix_filter. This is a way to notify the neighbor of the prefix filter whenever a change is made to the prefix filter. Format clear bgp [all | ipaddr | as | peer_group | external] {soft {[in {prefix_filter} | out]}} Parameters all - Specifies that all current BGP sessions will be reset. ipaddr - Specifies to reset the session with the specified neighbor. - Enter the IP address used for this configuration here. as - Specifies to reset sessions with BGP peers in the specified Autonomous System. - Enter the AS number used here. This value must be between 1 and 65535. peer_group - Specifies to reset a peer group. 180