D-Link DGS-3620-52T CLI Guide - Page 331
debug ripng flag
View all D-Link DGS-3620-52T manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 331 highlights
xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide Example To disable the PIM-SSM debug function: DGS-3620-28SC:admin# no debug pim ssm Command: no debug pim ssm Success. DGS-3620-28SC:admin# 20-70 debug ripng flag Description This command is used to enable or disable the RIPng debug flag. Format debug ripng flag [{interface | packet [all | rx | tx] | route} | all] state [enable | disable] Parameters interface - (Optional) Specifies the state of the RIPng interface debug. The default setting is disabled. packet - (Optional) Specifies which packets should be set with debug flags. all - Specifies to set all packets with debug flags. rx - Specifies to set inbound packets with debug flag. tx - Specifies to set outbound packets with debug flag. route - (Optional) Specifies the state of the RIPng route debug. The default setting is disabled. all - Specifies to set all debug flags. state - Specifies the designated flags state. enable - Specifies that the designated flags state will be enabled. disable - Specifies that the designated flags state will be disabled. Restrictions Only Administrator-level users can issue this command. (EI Mode Only Command) Example To enable the RIPng debug: DGS-3620-28SC:admin# debug ripng state enable Command: debug ripng state enable Success. DGS-3620-28SC:admin# After enabling RIPng on an interface, the following information may appear when the interface state changes. 326