D-Link DGS-3620-52T CLI Guide - Page 24

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide Restrictions None. Example To display the console port setting: DGS-3620-28SC:admin#show serial_port Command: show serial_port Baud Rate Data Bits Parity Bits Stop Bits Auto-Logout : 115200 : 8 : None : 1 : 10 mins DGS-3620-28SC:admin# 2-13 config serial_port Description This command is used to configure the serial bit rate that will be used to communicate with the management host and the auto logout time for idle connections. Format config serial_port {baud_rate [9600 | 19200 | 38400 | 115200] | auto_logout [never | 2_minutes | 5_minutes | 10_minutes | 15_minutes]}(1) Parameters baud_rate - Specify the baud rate value. The default baud rate is 115200. 9600 - Specify a baud rate of 9600. 19200 - Specify a baud rate of 19200. 38400 - Specify a baud rate of 38400. 115200 - Specify a baud rate of 115200. auto_logout - Specify the timeout value. The default timeout is 10_minutes. never - Specify to never timeout. 2_minutes - Specify when the idle value is over 2 minutes, the device will auto logout. 5_minutes - Specify when the idle value over 5 minutes, the device will auto logout. 10_minutes - Specify when the idle value is over 10 minutes, the device will auto logout. 15_minutes - Specify when the idle value is over 15 minutes, the device will auto logout. Restrictions Only Administrator and Operator-level users can issue this command. Example To configure the baud rate: DGS-3620-28SC:admin# config serial_port baud_rate 9600 19