D-Link DGS-3620-52T CLI Guide - Page 782
create ospfv3 area
View all D-Link DGS-3620-52T manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 782 highlights
xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide Restrictions Only Administrator, Operator and Power-User level users can issue this command. (EI Mode Only Command) Example To set OSPFv3 router ID: DGS-3620-28SC:admin# config ospfv3 router_id 1.1.1.1 Command: config ospfv3 router_id 1.1.1.1 Success. DGS-3620-28SC:admin# 70-5 create ospfv3 area Description This command is used to create an OSPFv3 area. Format create ospfv3 area type [normal | stub {stub_summary [enable | disable] | metric }] Parameters - Specifies the OSPFv3 area's ID. It is a 32-bit number in the form of an IPv4 address that uniquely identifies the OSPFv3 area in the OSPFv3 domain. type - Specifies the OSPFv3 area mode of operation. There are two types: normal - Specifies that the OSPFv3 area will be created as a normal area. stub - Specifies that the OSPFv3 area will be created as a stub area. stub_summary - (Optional) Specifies the OSPFv3 stub area to import inter-area prefix LSA advertisements or not. enable - Import inter-area prefix LSA into this stub area. disable - Do not import inter-area prefix LSA into this stub area. metric - (Optional) Specifies the default cost of OSPFv3 stub area. - Enter the metric value used here. This value must be between 0 and 65535. The default value is 1. Restrictions Only Administrator, Operator and Power-User level users can issue this command. (EI Mode Only Command) Example To create OSPFv3 areas: 777