D-Link DGS-3620-52T CLI Guide - Page 894

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide Format config scheduling {ports [ | all]} [strict | weight ] Parameters ports - (Optional) Specifies the range of ports to be configured. - Enter the list of ports here. all - Specifies that all the ports will be used. - Specifies the 8 hardware priority queues that the config scheduling command will apply to. The eight hardware priority queues are identified by a number from 0 to 7 with the 0 queue being the lowest priority. strict - Specifies that the queue will operate in strict mode. weight - Specifies the weight value for weighted round robin. The queue will operate in WRR mode if the port mode is WRR. It will operate in strict mode if the port mode is strict. - Enter the weight value here. This value must be between 1 and 127. Restrictions Only Administrator, Operator and Power-User level users can issue this command. Example To configure the traffic scheduling on CoS queue 0 with a maximum packet value of 10: DGS-3620-28SC:admin#config scheduling 0 weight 10 Command: config scheduling 0 weight 10 Success. DGS-3620-28SC:admin# To configure the traffic scheduling on CoS queue 1, with a weight value of 25, on port 1:10: DGS-3620-28SC:admin# config scheduling ports 1:10 1 weight 25 Command: config scheduling ports 1:10 1 weight 25 Success. DGS-3620-28SC:admin# 81-6 config scheduling_mechanism Description This command is used to configure the traffic scheduling mechanism for each CoS queue. Format config scheduling_mechanism {ports [ | all]} [strict | wrr] 889