D-Link DGS-3620-52T CLI Guide - Page 851
Port Security, Commands
View all D-Link DGS-3620-52T manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 851 highlights
xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide Chapter 76 Port Security Commands config port_security ports [ | all] [{admin_state [enable | disable] | max_learning_addr | lock_address_mode [permanent | deleteontimeout | deleteonreset]}(1) | {vlan [ | vlanid ] max_learning_addr [ | no_limit]}(1)] config port_security system max_learning_addr [ | no_limit] config port_security vlan [ | vlanid ] max_learning_addr [ | no_limit] delete port_security_entry [vlan | vlanid ] mac_address clear port_security_entry {ports [ | all] | {[vlan | vlanid ]}} show port_security_entry {ports {} {[vlan | vlanid ]}} show port_security {ports {} {[vlan | vlanid ]}} enable port_security trap_log disable port_security trap_log 76-1 config port_security ports Description This command is used to set the port's state, maximum supported MAC address entries, the default entry type, and set the maximum port-security entries that can be learned with a specific VLAN on a specific port. There are four levels of limitations on the learned entry number, for the entire system, for a port, for a VLAN, and for specific VLAN on a port. If any limitation is exceeded, the new entry will be discarded. Format config port_security ports [ | all] [{admin_state [enable | disable] | max_learning_addr | lock_address_mode [permanent | deleteontimeout | deleteonreset]}(1) | {vlan [ | vlanid ] max_learning_addr [ | no_limit]}(1)] Parameters - Specify a range of ports to be configured. all - Specify that all ports will be configured. admin_state - Allow the port security to be enabled or disabled for the ports specified in the port list. The default setting is disabled. enable - Enable port security for the ports specified in the port list. disable - Disable port security for the ports specified in the port list. max_learning_addr - Specify the maximum of MAC address entries that can be learned on this port. If the value is set to 0, it means that no user can get authorized by the port security function on this port. If the setting is smaller than the number of current learned entries on the port, the command will be rejected. The default value is 32. - Specify the value between 0 and 3328. lock_address_mode - Indicate locking address mode. The default mode is deleteonreset. permanent - The address will never be deleted unless the user removes it manually or the 846