D-Link DGS-3620-52T CLI Guide - Page 540

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide Inspection. forward_dhcppkt - (Optional) By default, the DHCP packets with broadcast DA will be flooded. enable - This setting is effective when DHCP snooping is enabled because the DHCP packet which has been trapped to CPU needs to be forwarded by the software. This setting controls the forwarding behaviour under this situation. disable - When set to disable, the broadcast DHCP packets received by the specified port will not be forwarded. stop_learning_threshold - (Optional) Enter the stop learning threshold value here. - The stop learning threshold value must be between 0 and 500. Restrictions Only Administrator, Operator and Power-User level users can issue this command. Example To configure port 1 to be enabled for address binding: DGS-3620-28SC:admin# config address_binding ip_mac ports 1 arp_inspection strict ip_inspection enable protocol ipv4 Command: config address_binding ip_mac ports 1 arp_inspection strict ip_inspection enable protocol ipv4 Success. DGS-3620-28SC:admin# 46-4 config address_binding ip_mac ipaddress Description This command is used to update an address binding entry. Format config address_binding ip_mac ipaddress mac_address {ports [| all ]} Parameters - Specify the IP address. mac_address - Specify the MAC address. - Enter the MAC address here. ports - (Optional) Configure the portlist to apply, if ports are not configured, then it will apply to all ports. - Specify the list of ports to apply. all - Specify to apply to all the ports. Restrictions Only Administrator, Operator and Power-User level users can issue this command. 535