D-Link DGS-3620-52T CLI Guide - Page 934
create sflow flow_sampler ports
View all D-Link DGS-3620-52T manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 934 highlights
xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide Example To display the sFlow information: DGS-3620-28SC:admin#show sflow Command: show sflow sFlow Version : V5 sFlow Address : 10.90.90.90 sFlow AddressV6: FE80::201:2FF:FE03:400 sFlow State : Enabled DGS-3620-28SC:admin# 87-4 create sflow flow_sampler ports Description This command is used to create the sFlow flow sampler. Format create sflow flow_sampler ports [ | all] analyzer_server_id {rate | tx_rate | maxheadersize } Parameters - Specify the list of ports to be configured. all - Specify to configure all ports. analyzer_server_id - Specify the ID of an analyzer server where the packet will be forwarded. - Specify the ID of an analyzer server where the packet will be forwarded. rate - (Optional) Specify the sampling rate for packet sampling. - Specify the sampling rate for packet sampling. The configured rate value multiplied by 256 is the actual rate. For example, if the rate is 20, the actual rate 5120. One packet will be sampled from every 5120 packets. If set to 0, the sampler is disabled. If the rate is not specified, its default value is 0. tx_rate - Specifies the transmit rate. - Enter the transmit rate used here. This value must be between 0 and 65535. maxheadersize - (Optional) Specify the maximum number of leading bytes in the packet which has been sampled that will be encapsulated and forwarded to the server. - Specify the maximum number of leading bytes in the packet which has been sampled that will be encapsulated and forwarded to the server. If not specified, the default value is 128. Restrictions Only Administrator and Operator-level users can issue this command. Example To create the sFlow flow sampler: DGS-3620-28SC:admin#create sflow flow_sampler ports 1 analyzer_server_id 1 rate 929