D-Link DGS-3620-52T CLI Guide - Page 706
Multicast Listener, Discovery MLD, Commands
View all D-Link DGS-3620-52T manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 706 highlights
xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide Chapter 64 Multicast Listener Discovery (MLD) Commands config mld [ipif | all] {query_interval | max_response_time | robustness_variable | last_listener_query_interval | version | state [enable | disable]} (1) show mld {ipif } show mld group {ipif | group } 64-1 config mld Description This command is used to configure MLD on the Switch. Format config mld [ipif | all] {query_interval | max_response_time | robustness_variable | last_listener_query_interval | version | state [enable | disable]} (1) Parameters ipif - Specifies the IP interface name used for this configuration. - Enter the IP interface name used here. This name can be up to 12 characters long. all - Specifies that all the IP interfaces will be used. query_interval - (Optional) Specifies the time in seconds between the general query transmissions. - Enter the general query interval value used here. This value must be between 1 and 31744 seconds. The default value is 125 seconds. max_response_time - (Optional) Specifies the maximum time in seconds to wait for reports from listeners. - Enter the maximum response time value used here. The value must be between 1 and 25 seconds. The default value is 10 seconds. robustness_variable - (Optional) Specifies the permitted packet loss that guarantees the MLD. - Enter the robustness variable value used here. This value must be between 2 and 7. The default value is 2. last_listener_query_interval - (Optional) Specifies the maximum response time inserted into the Multicast address specific query sent in response to 'done group' messages. This is also the amount of time between Multicast address specific query messages. - Enter the last listener query interval value used here. This value must be between 1 and 25 seconds. The default value is 1 second. version - (Optional) Specifies the MLD version number. - Enter the MLD version number used here. This number must be between 1 and 2. The default value is 2. state - (Optional) Specifies the MLD state for the specified route interface. enable - Specifies that the MLD state for the specified interface will be enabled. 701