D-Link DGS-3620-52T CLI Guide - Page 892

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide 1 No Limit 2 No Limit No Limit No Limit DGS-3620-28SC:admin# No Limit No Limit No Limit No Limit 81-3 config per_queue bandwidth_control Description This command is used to set the bandwidth control for each specific egress queue on specified ports. The maximum rate limits the bandwidth. When specified, packets transmitted from the queue will not exceed the specified limit even if extra bandwidth is available. The specification of maximum rate is effective regardless of whether the queue is operating in strict or Shaped Deficit Weighted Round Robin (SDWRR) mode. Format config per_queue bandwidth_control {ports [ | all]} {{min_rate [no_limit | ]} max_rate [no_limit | ]}(1) Parameters ports - (Optional) Specify a range of ports to be configured. - Specify a range of ports to be configured. all - Specify to set all ports in the system. If no parameter is specified, the system will set all the ports. - Specify a list of priority queues. The priority queue number ranges from 0 to 7. min_rate - Specify that one of the parameters below will be applied to the minimum rate that the class specified above will be allowed to transmit packets at. no_limit - Indicates there is no limit on egress queue of specified port bandwidth. - Specify an integer value from 64 to 10240000 to set a minimum limit in Kbits/sec. The specified bandwidth limit may be equaled but not exceeded. The exact logical limit or token value is hardware determined. Note: 1 Kbit = 1000 bits, 1 Gigabit = 1000*1000 Kbits. Actual rate = (inputted rate/ 64) * 64. max_rate - Specify one of the parameters below will be applied to the maximum rate that the class specified above will be allowed to transmit packets at. no_limit - Indicates there is no limit on egress queue of specified port bandwidth. - Specify an integer value from 64 to 10240000 to set a maximum limit in Kbits/sec. The specified bandwidth limit may be equaled but not exceeded. The exact logical limit or token value is hardware determined. Note: 1 Kbit = 1000 bits, 1 Gigabit = 1000*1000 Kbits. Actual rate = (inputted rate/ 64) * 64. Restrictions Only Administrator, Operator and Power-User level users can issue this command. Example To configure the maximum rate to be 100 on queue 1 for ports 1 to 10: DGS-3620-28SC:admin#config per_queue bandwidth_control ports 1-10 1 max_rate 100 Command: config per_queue bandwidth_control ports 1-10 1 max_rate 100 887