D-Link DGS-3620-52T CLI Guide - Page 533
config ipv6 nd ra ipif
View all D-Link DGS-3620-52T manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 533 highlights
xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide Example To configure the NS retransmit time of a specified interface: DGS-3620-28SC:admin#config ipv6 nd ns ipif System retrans_time 400 Command: config ipv6 nd ns ipif System retrans_time 400 Success. DGS-3620-28SC:admin# 45-5 config ipv6 nd ra ipif Description This command is used to configure the RA parameters of a specified interface. Format config ipv6 nd ra ipif {state [enable | disable] | life_time | reachable_time | retrans_time | hop_limit | managed_flag [enable | disable] | other_config_flag [enable | disable] | min_rtr_adv_interval | max_rtr_adv_interval }(1) Parameters - Specify the name of the interface. state - Specify the router advertisement status. enable - Enable the router advertisement state. disable - Disable the router advertisement state. life_time - Specify the lifetime of the router as the default router, in seconds. - Specify the time between 0 and 9000 seconds. reachable_time - Specifies the amount of time that a node can consider a neighboring node reachable after receiving a reachability confirmation in millisecond. - Specify the time between 0 and 3600000 milliseconds. retrans_time - Specifies the amount of time between retransmissions of router advertisement message in millisecond, and the router advertisement packet will take it to host. - Specify the time between 0 and 4294967295 milliseconds. hop_limit - Specify the default value of the hop limit field in the IPv6 header for packets sent by hosts that receive this RA message. - Specify the value between 0 and 255. managed_flag - Specify to enable or disable the function. enable - When set to enable, it indicates that hosts receiving this RA must use a stateful address configuration protocol to obtain an address, in addition to the addresses derived from the stateless address configuration. disable - Set to disable to stop hosts receiving the RA from using a stateful address configuration to obtain an address. other_config_flag - Specify to enable or disable the function. enable - When set to enable, it indicates that hosts receiving this RA must use a stateful address configuration protocol to obtain on-address configuration information. disable - Set to disable to stop hosts receiving this RA from using a stateful address configuration protocol to obtain on-address configuration information. min_rtr_adv_interval - Specify the minimum time allowed between sending unsolicited multicast Router Advertisements from the interface, in seconds. It must be no less than 3 seconds and no greater than .75 * MaxRtrAdvInterval. The default is 0.33 * MaxRtrAdvInterval. - Specify the time between 3 and 1350 seconds. max_rtr_adv_interval - Specify the maximum time allowed between sending unsolicited 528