D-Link DGS-3620-52T CLI Guide - Page 183

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide Restrictions Only Administrator, Operator and Power-User level users can issue this command. (EI Mode Only Command) Example This example shows how to configure the cluster ID: DGS-3620-28SC:admin# config bgp route_reflector cluster_id 10.100.200.1 Command: config bgp route_reflector cluster_id 10.100.200.1 Success. DGS-3620-28SC:admin# 12-31 config bgp client_to_client_reflection Description This command is used to configure the BGP client to client reflection setting. If the reflection is disabled, then the router will not reflect routes from the route reflect client to other route reflect clients, but it will still send routes received from a non-reflecting client to a reflecting client. Format config bgp client_to_client_reflection [enable | disable] Parameters enable - The reflector will operate in reflector mode. disable - The reflector will operate in non-reflector mode. Restrictions Only Administrator, Operator and Power-User level users can issue this command. (EI Mode Only Command) Example This example shows how to disable the client to client reflection: DGS-3620-28SC:admin# config bgp client_to_client_reflection disable Command: config bgp client_to_client_reflection disable Success. DGS-3620-28SC:admin# 178