D-Link DGS-3620-52T CLI Guide - Page 841
show pim6 mroute s_g
View all D-Link DGS-3620-52T manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 841 highlights
xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide Example To configure the multicast routing keepalive period to be 220 seconds: DGS-3620-28SC:admin# config pim6 keepalive_period 220 Command: config pim6 keepalive_period 220 Success. DGS-3620-28SC:admin# 74-23 show pim6 mroute s_g Description This command is used to display the multicast routing information for (S, G) or (S, G, rpt) entries generated by PIM6. Format show pim6 mroute s_g {rpt} {group source {ipif }} Parameters rpt - (Optional) Specifies the (S, G, rpt) entry. group - (Optional) Specifies the IPv6 multicast group address. - Enter the IPv6 multicast group address used here. source - (Optional) Specifies the source IPv6 interface. - Enter the IPv6 interface network address used here. ipif - Specifies the IPv6 interface name. - Enter the IPv6 interface name here. This name can be up to 12 characters long. If no parameter is specified, the switch will display all the (S, G) route entries in the IPv6 multicast routing table in brief. If only specified parameter {rpt}, the switch will display all the (S, G, rpt) route entries in the IPv6 multicast routing table in brief. Restrictions None. (EI Mode Only Command) Example To show all (S, G) route entries generated on the switch: DGS-3620-28SC:admin# show pim6 mroute s_g Command: show pim6 mroute s_g (S, G) Entry Table Group : FF13::100 Source : 2001::1111 Group : FF13::100 Source : 2001::2222 836