D-Link DGS-3620-52T CLI Guide - Page 118
Optional Specifies the TCP protocol
View all D-Link DGS-3620-52T manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 118 highlights
xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide - Enter the IPv6 source address mask value here. destination_ipv6 - (Optional) Specifies the value of IPv6 destination address. - Enter the source IPv6 destination address here. mask - Specifies the IPv6 destination address mask here. - Enter the IPv6 destination address mask value here. tcp - (Optional) Specifies the TCP protocol src_port - Specifies the value of the IPv6 layer 4 TCP source port. - Enter the IPv6 TCP source port value here. This value must be between 0 and 65535. mask - Specifies the IPv6 TCP source port mask here. - Enter the IPv6 TCP source port mask value here. dst_port - Specifies the value of the IPv6 layer 4 TCP destination port. - Enter the IPv6 TCP destination port value here. This value must be between 0 and 65535. mask - Specifies the IPv6 TCP destination port mask here. - Enter the IPv6 TCP destination port mask value here. udp - (Optional) Specifies the UDP protocol. src_port - Specifies the value of the IPv6 layer 4 UDP source port. - Enter the IPv6 UDP source port value here. This value must be between 0 and 65535. mask - Specifies the IPv6 UDP source port mask here. - Enter the IPv6 UDP source port mask value here. dst_port - Specifies the value of the IPv6 layer 4 UDP destination port. - Enter the IPv6 UDP destination port value here. This value must be between 0 and 65535. mask - Specifies the IPv6 UDP destination port mask here. - Enter the IPv6 UDP destination port mask value here. icmp - (Optional) Specifies that the following parameters configured will apply to the ICMP configuration. type - Specifies that the rule will apply to the ICMP type traffic value. - Enter the ICMP traffic type value here. This value must be between 0 and 255. code - Specifies that the rule will apply to the ICMP code traffic value. - Enter the ICMP code traffic value here. This value must be between 0 and 255. vlan_based - The rule applies on the specified VLAN. vlan - Specifies the VLAN name. - Enter the VLAN name used for this configuration here. This name can be up to 32 characters long. vlanid - Specifies a VLAN ID. - Enter the VLAN ID used for this congfiguration here. This value must be between 1 and 4094. port_group - Specifies the port group value here. id - Specifies the ID of the port group which the rule applies. - Enter the group ID value here. This value must be between 1 and 64. name - Specifies the name of the port group which the rule applies. - Enter the port group name here. This name can be up to 16 characters long. port - Specifies the port in the port group used. - Enter the port number used here. permit - Specifies that packets matching the egress access rule are permitted by the switch. replace_priority_with - (Optional) Specifies the packets that match the egress access rule are changed the 802.1p priority tag field by the switch. - Enter the replace priority with value here. This value must be between 0 and 7. replace_dscp_with - (Optional) Specifies the packets that match the egress access rule are changed the DSCP value by the switch. - Enter the replace DSCP with value here. This value must be between 0 and 63. counter - (Optional) Specifies whether the ACL counter feature is enabled or disabled. This parameter is optional. The default option is disabled. If the rule is not bound with the flow_meter, all matching packets are counted. If the rule is bound with the flow_meter, then 113