D-Link DGS-3620-52T CLI Guide - Page 872
sync_interval
View all D-Link DGS-3620-52T manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 872 highlights
xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide Parameters ports - Specifies the list of port used for this configuration. - Enter the list of port used for this configuration here. all - Specifies that all the ports will be used for this configuration. announce - (Optional) Specifies that the announce options will be configured. interval - Specifies the mean time interval between successive announce messages. In line with the IEEE 1588 protocol, the value of the announce interval is represented as the logarithm to the base 2 of this time measured in seconds. If the input is not allowed, then the input is automatically adjusted to allow the bigger and closest value. The value of the announce interval should be uniform throughout a domain. If the announce interval of one port changes, the announce interval of all the ports must be changed automatically to be consistent. - Enter the interval value used here. This value must be between 1 and 16 seconds. timeout - Specifies the announce interval number that has to pass without receiving an Announce message before the occurrence of the ANNOUNCE_RECEIPT_TIMEOUT_EXPIRES event. This value multiplied by the announce interval value is equal to the interval time of the announce receipt timeout. The value of the interval time of the announce receipt timeout should be uniform throughout a domain. If the value of one port is changed, the value of all ports must be changed automatically to be consistent. - Enter the timeout value used here. This value must be between 2 and 10 seconds. sync_interval - (Optional) Specifies the mean time interval between successive Sync messages. half_second - Specifies that the syncronization interval will be set to half a second. - Enter the syncronization interval value used here. This value must be between 1 and 2. delay_req_interval - (Optional) Specifies the permitted mean time interval between successive delay request messages which are sent by a slave to a specific port on the master. This mean time interval value is determined and advertised by a master. - Enter the delay required interval value used here. This value must be between 0 and 5. pdelay_req_interval - (Optional) Specifies the permitted mean time interval between successive pdelay_request messages. - Enter the permitted mean time interval value used here. This value must be between 1 and 32 seconds. delay_mechanism - (Optional) Specifies the mechanism for measuring the propagation delay time of an event message. e2e - E2E indicates that the port is configured to use the delay request-response mechanism. p2p - P2P indicates that the port is configured to use the peer delay mechanism. Restrictions Only Administrator, Operator and Power-User level users can issue this command. Example To configure the announce interval attribute of ports 1-4 to 3 seconds: DGS-3620-28SC:admin# config ptp boundary ports 1:1-1:4 announce interval 3 Command: config ptp boundary ports 1:1-1:4 announce interval 3 The announce interval is automatically adjusted to 4. Success. DGS-3620-28SC:admin# 867