D-Link DGS-3620-52T CLI Guide - Page 702

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide Chapter 63 Modify Login Banner and Prompt Commands config greeting_message {default} show greeting_message config command_prompt [ | username | default] 63-1 config greeting_message Description This command is used to modify the login banner. Format config greeting_message {default} Parameters default - (Optional) Adding this parameter to the config greeting_message command will return the greeting message (banner) to its original factory default entry. Restrictions  When users issue the "reset" command, the modified banner will remain in tact. Yet, issuing the "reset system" will return the banner to its original default value.  The maximum character capacity for the banner is 24 lines with 80 characters per line.  In the following example, Ctrl+W will save the modified banner only to the DRAM. Users must enter the "save" command to save this entry to the Flash memory.  Only Administrator and Operator-level users can issue this command. Example To edit the banner: DGS-3620-28SC:admin#config greeting_message Command: config greeting_message Greeting Messages Editor DGS-3620-28SC Gigabit Ethernet Switch Command Line Interface Firmware: Build 2.00.015 Copyright(C) 2012 D-Link Corporation. All rights reserved. 697